Dish Network 3 Průvodce nastavením stáhnout pdf (Strana 17)

206-4180

View the Pro:Idiom Key Checksum

Use the following procedure to display the Pro:Idiom key checksum.

1. Connect a PC to the HCS7720 Service Port, and access the Main Menu as described on

page 15.

2. At the Main Menu

Command >

prompt, type the menu command that corresponds to the

Read PI Key Checksum option and press Enter to display the Pro:Idiom key checksum,

for example:

PI key checksum is xxxxxxxxxx

where

xxxxxxxxxx

is a 10-digit number that identifies the Pro:Idiom key file installed on

the transcoder.

Note: All transcoder cards in the card frame must have the same Pro:Idiom key

file installed.

Reload the Pro:Idiom Key

Use the following procedure, as necessary, to reload the Pro:Idiom key.

1. Connect a PC to the HCS7720 Service Port, and access the Main Menu as described on

page 15.

2. At the Main Menu

Command >

prompt, type the menu command that corresponds to the

Reload PI Key option and press Enter.

3. At the

Reload PI key. Continue (y/n)?

prompt, type y and press Enter to

continue.

When the reload is complete, the system will display:

Reload PI complete OK

View System Information

Use the following procedure to display HCS7720 hardware and software information.

1. Connect a PC to the HCS7720 Service Port, and access the Main Menu as described on

page 15.

2. At the Main Menu

Command >

prompt, type the menu command that corresponds to the

Read Transcoder Information option and press Enter.

The System Information display contains important information about the HCS7720, including

the unit hardware ID (firmware version), software versions, MAC address, and serial number,

for example:

Conguration Options (Cont.)

(Continued on next page)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Komentáře k této Příručce

Žádné komentáře

Dish Network 3 Průvodce nastavením Strana 17

Komentáře k této Příručce

Související produkty a manuály pro Dálková ovládání Dish Network 3