Dish Network Switch DP21 Uživatelský manuál

120131DishPro 21 Multi-Dish SwitchInstallation Guide

107. If you still do not see the Satellite reception verified message,call the DISH Network Customer Service Center at 1-800-333-DISH (3474).Operating

11Figure 4. DISH 500 with DishPro Twin LNBF,DISH 300 with a Single LNBF, Two DP21 Switches, and aDishPro Compliant Splitter. Supports two receivers fr

12Figure 5. Two DISH 300s with Single DishPro LNBFs, TwoDP21 Switches, and Two DishPro Compliant Splitters.Supports two receivers from two satellite l

13Figure 6. One Dish 500 with a Twin LNBF, One Dish 300with a Single LNBF, and One DP21 Switch. Supports onereceiver from three satellite locations an

14Limited WarrantyThis warranty extends only to the original user of the DISH Network™DP21Switch (“you,” “your”) and is limited to the purchase price

15USE OF, OR INABILITY TO USE, THIS DEVICE. UNDER NOCIRCUMSTANCES SHALL OUR LIABILITY, IF ANY, EXCEED THEPURCHASE PRICE PAID FOR THIS DEVICE. EXCEPT T

16The shipping charge, for receiving replacement equipment and returning thedefective equipment, is a one time fee based on EchoStar's competitiv

17Accessory WarrantyAn accessory is any DISH Network branded equipment, displaying the DISHNetwork logo, excluding the receiver, Smart Card, cables an

18We will:Check the switch, including whether it is covered under the warranty.Replace any switch that we find is defective with a new or refurbished

Copyright © 2003, EchoStar Technologies Corporation, Englewood,Colorado 80112. All rights reserved.The information in this Guide may change without no

Important Safety InstructionsYou must keep safety in mind when you install and use the DP21 switch.Refer to the safety instructions in the installatio

3ContentsIntroduction...page 4How to Install the DP21 Switch ...page 5Operating with a DishProCompliant Splitter .

4IntroductionA DishPro 21 (DP21) Multi-Dish Switch allows you to receive signalsfrom two DishPro LNBFs, and route these signals to a DishPro satellite

5How to Install a DP21 SwitchThe following instructions assume you have alreadypointed your dish for the strongest possible signal, that youhave run C

62. Connect the coaxial cables from a DISH 500 or a DISH 300 to theports on the DP21 switch labeled To Dish as shown in the wiringdiagrams that begin

7Figure 1. Point Dish/Signal4. The Check Switch procedure will run. When it finishes, you willsee an Installation Summary screen similar to Figure 2 o

8Figure 2. Installation Summarywith Identified DevicesNote: If you use a DishPro compliant splitter, one side of the splitterblocks the communications

9Figure 3. Installation Summarywithout Identified Devices5. If the Installation Summary does not show that Check Switchcompleted successfully as shown